How to Make a Hemp Bracelet

In this article you will learn.

1st How to make a hemp bracelet.

2nd How to make a macrame half knot, square knot and a knot on his hand.

3. Instructions given to network so you can weave your hemp bracelet.

4. A guide will like the property to create hemp bracelet patterns, and the spiral hemp bracelet pattern.

5. You will learn how to adjust the length of the strap so that one size fitall.

Material

-Hemp

Recommended Pearls ()

Scissors

The first step to a hemp bracelet is cutting your hemp twine to the right length. Cut two pieces of twine and make it ten feet long. These are your knotted strings. Next cut a piece of thin hemp twine and make it a long and half a meter. This will be your center cord.

Like a knot in his tie over his hand.

Take one or more cables and held it together to makea loop, pull the ends under and threw.

Thus begin the hemp bracelet bearing the two knotted strings and tie them together with a knot on his hand. Next measure out two inches and one on the hand knot with two strands of the knot and the center cable.

How to make a braid hemp bracelet.

Take the cable on the right side and bring it over the middle cable and place it between the other cords. Then take the left cord over the center line and place it between the other cords. Repeatuntil the desired length.

Following the overhand knot, which made you just start braiding the three strands together for two inches. Finish of the braid by tying a knot on his hand.

Before we start the macrame portion of the bracelet, it is important that we tie a macrame half knot and a macrame square knot to learn.

How to tie a half knot.

Start by organizing your three strands shows up. Take the cable knots and fold it into a ninetyDegree angle over the center cable. Bring the opposite knot cord over the first knot cord under the center string and up threw the loop created by the first node string. They have completed a macrame half knot.

A square knot consists of two nodes that are opposites of each other half made. Meaning half of nodes are started on the left side and the second half started on the right node.

How to create a hemp bracelet spiral pattern and a flat pattern.

The spiralPattern is, if you will tie together a series of half knots, and the flat pattern, if you have a series of square knots to bind together.

Now that you know how to tie half knots and square knot in a spiral pattern or flat, you can start the macrame portion of your hemp bracelet. To the beads to a hemp bracelet tie knots add up to the location where you can go want to add a ball to get. Put a pearl in the center line and slide it up against the last knot you tied. Next tie a knotbehind the ball, they held firmly in place. Add more beads and tying knots until you have your desired length. Finish the macrame portion of the hemp bracelet by tying a knot on his hand.

Again, to start braiding until you have an inch pigtail. Tie the braid with one hand over nodes.

Take the two knotted cords and tie them together with a knot on his hand two inches from the end of the braid.

Cut off excess cable and your hemp braceletcompleted.

You can adjust the length of your hemp bracelet by you bind it to the desired length with the braided portion of you hemp bracelet.